- Philips M2601A S03 (EASI) ECG Telemetry Transmitter
† Telemetry devices can be directly connected to monitor telemetry data (ECG/SpO2) on the MP5 screen (Telemetry as a parameter (TAAP)). † The MP5 with IntelliVue Instrument Telemetry can be declared as a telemetry device at the Information Center and paired with a monitor. † The monitor can operate using battery power for up to four hours.
Page 1 IntelliVue Telemetry System Infrastructure Installation and Service Guide Patient-worn Transceivers 1.4/2.4 GHz Access Points ITS Synchronization Unit ITS Power over Ethernet Unit Access Point Controller ICN Network Switch Part Number: M3185-91934 Printed in the U.S.A. June, 2007 Second Edition.M3185-91934. Connectivity to TeleMon for display of patient measurements - including NBP - at the bedside. Diagram to come System Information Flow/Smart-hopping The IntelliVue Transceiver The Philips IntelliVue transceiver is a patient-worm device for monitoring ECG and SpO2 on adult and pediatric patients in the IntelliVue Telemetry System Basic Operation. If the transmitter is a standard ECG transmitter, replace with a 3- or 5-wire leadset. If the transmitter is an EASI ECG transmitter, a 5-wire must be used. If the transmitter is an EASI ECG transmitter, this INOP will appear if monitoring is attempted while a 3-wire leadset is attached to the transmitter. Attach a 5-wire leadset.
Product Description
The Philips M2601A Telemetry system transmitter sends continuous ECG and SpO2 measurements to the IntelliVue Information Center, where the measurements are captured, analyzed, displayed, and stored.
The basic setup comes with 3-lead or 5-lead capability. The ECG-only transmitter is particularly light and comfortable for patients. Upgraded transmitters combine standard and EASI derived 12-lead ECG monitoring on a single device, run on easily replaceable AA batteries, and provide audio feedback for many tasks, including “power on” and SpO2 spot check.
Features:
- Frequency of 460-480 MHz or 608-614 MHz WMTS
- Lightweight—less than ½ lb.
- Standard ECG configuration with 3- or 5-lead capability
- EASI ECG configuration used for transmitters that work with central stations that are capable of converting a 5-wire lead set signal to 12 lead analysis by having EASI version software installed at the central station.
- SpO2 configuration used for transmitters that are used with SpO2 sensors.
Telemetry Monitor Placement
Add SpO2 Probe (Only Available with S02 Model):
